I have a couple C5 Blazer seats in extremely good condition for sale - with seat rails - perfect for the older hotrods - sit flat to floor and some of the most comfy I ever sat in $250 obo
42-48 Ford gauges, speedometer cable, vacumn wiper motor and knob - all in good working condition - $120 for the lot, Dash plastic sold
42-48 ford painted bumpers and bumperettes - $100 for all
68-72 chevelle SS boxed lower rear control arms $100 obo
70 chevelle rear bumper brackets $80 obo
2 complete reese adjustable 2 5/16 hitches with control bars and brackets - one has the sway bar as well $180 obo each
rechromed 40-41 Ford front bumperrettes - new never mounted very very nice $150
pics available for the little stuff - seems the site wont let me add any more pics
may consider trades on any or all of it.
looking for a very good spreadbore holley carb, or a Fitech or similar fuel injection setup, 5x5x15 chevy mags of some sort - not factory, or a built T350 trans, rust free 53-55 F1 cab and or doors, and front fenders
will add cash for some of it
pm me here or email me at ckr5610@hotmail.com
thanks
Ken
-- Edited by Seeker1056 on Friday 18th of September 2020 01:47:02 PM
-- Edited by Seeker1056 on Friday 18th of September 2020 01:47:56 PM
-- Edited by Seeker1056 on Friday 18th of September 2020 01:48:30 PM
Hello, I would like to buy your 46 ford bumpers for $100.
I live in Ottawa, do you ever drive up to Ottawa?
If not guess I'll put the pedal to the metal and come for a visit....
Cheers, Gary
I know of two spread bore carbs by holley
a 650 cfm and an 830 cfm
only diff is the secondaries are larger
float bowles and metering plates are unique to these carbs
they use a fuel transfer tube rather than the duel feed setup seen on DP carbs
- I can't remember off hand but I think this carb has duel acc pumps .. but it's been a long time since I looked at it last .. I could be mistaken
I found mention of this in a holley book that's out on loan at the moment so I can't site specs..
I do have one of the 830's though.. BUT it's apart , half polished and sitting in a box with two rebuild kits..
note the rebuild kits are only found under a listing for the 650's
the throttle plate on this one was seized when I got it but it works beautifully now after it soaked for 6 months in a pan full of rust check
I have two bucks into the carb and about 150 in the rebuild kits
