Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: 1968 Mustang drag car project


SW ONTARIO

Status: Offline
Posts: 50
Date:
1968 Mustang drag car project
Permalink  
 


Selling my 1968 Mustang coupe drag car project that I haven't had time for in the last few years. It isn't wired up for anything right now. 
YES I have the ownership. 
I don't have the front grill/horse
302 ford with an edelbrock aluminum intake, and AOD ford trans that are not installed. They did NOT come with the car when I bought it. The engine is from an early 80's T-bird, and the trans is from a late 80's Mustang.

8.8 rear end with 4:11 gears 

The exhaust is a quad setup with cut outs. Two pipes have mufflers, and run out the back. The other two are blocked off with cut off valves for running at the track. 

6-point roll cage welded in

Bucket seats, rear bench seat, set of fiberglass front fenders, extra stock hood with signals, and extra trunk included. Extra hood, and trunk are blue/teal.

Keep in mind this is a project car, but a good blank slate to start off with. I know I have forgotten a ton of info on this, so if you have any questions feel free to PM me. 

Looking for $3500/OBO (reasonable offers only I have over $3500 invested in it) I will consider trades for a pickup truck/other classic.
I'm sick of the kijiji no shows, or guys showing up with $2000 and thinking I'm just going to give it away. 

The car is currently stored in my enclosed car trailer, but can be viewed anytime. 
Located in West Lorne, dead center between London, and Chatham.



__________________


CLINTON, ONT

Status: Offline
Posts: 3909
Date:
Permalink  
 

Very nice     a lot of Mustang for 3500.00    hope it sells   



__________________

 

 



SW ONTARIO

Status: Offline
Posts: 50
Date:
Permalink  
 

SOLD!

__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.



Create your own FREE Forum
Report Abuse
Powered by ActiveBoard