427CARL wrote:

---

Fords  Mopar  Chevy ??  

---

Carl you missed, Studebaker, Willy's, Packard, Graham- Paige, Kaiser-Fraser, ETC & OH YA,  Avanti II!!!  getting back on track, all D/shafts have all different specs, not just length, U/joint sizes, hoop size + diameter!!!! Then you get to the front yoke & theres all diff. sizes,splines, & lengths for each transmission  manufacturer!!!  You may get lucky & find one in wreckers or someone here has saved a few but "odds are " get one made at specialty fab. shop & save your self a lot of grief looking for one> 

Thanks Guys...I realize I was kind of vague on what I was looking for.....my application is a Chev 350 tranny with a 2000 s10 4 x 4 rear end....and when I googled I also see many people jumped on others asking same thing lol......was just wondering if someone had compiled a list like was done for springs, rear ends etc....

I will try a local wrecker and see if I get lucky...

Rochie..... Knuckles,
try London Driveline Matt will take care of you      

Is this for a custom made shaft?....

Thanks     

This is a good place to start and a little reading will save you a lot of trouble down the road

http://www2.dana.com/pdf/J3311-1-DSSP.pdf

Pay attention to page 5 universal joint operating angles and rules. 

local shops and information that have came up.... search....driveshafts..... ^^^^^

Check this video if you want to understand driveline angles.

http://www.macsmotorcitygarage.com/2014/07/26/video-driveshaft-angle-and-phasing/